Bedec Extra-Flex Masonry paint is ideally suited for the protection of exterior masonry, roughcast, pebble-dash, brickwo r k , cement and concrete rendered surfaces.
It can be applied to previously painted surfaces after suitable preparation
This modified acrylic blend is a flexible microporous protective coating that will flex with the substrate where movement causes cracking in conventional masonry paint.
Directions for use
Stir thoroughly, check colour before use. Apply by brush roller or spray (use HVLP or Airless spray for best results). Do not apply at temperatures below 10o Centigrade or when foggy or likely to rain before the paint has dried. Ensure all surfaces are free from oil, grease, dirt, dust and loose particles. On existing painted surfaces, remove all loose and flaking paint and thoroughly rub down with abrasive paper. Areas affected by mould, lichen, algae or moss should be treated with a suitable fungicidal wash. On untreated, new cement, render etc. or any porous substrate the first coat should be thinned with approx. 30% clean water. Then apply at least two full coats for maximum protection.
5 litres will cover approx. 50 square metres per coat depending upon substrate texture, porosity and application method.
Touch dry 2 hours, recoatable after 4 hours at 18oC 65% relative humidity.
Clean tools and equipment with water immediately after use.
Brilliant White, Black, Old White, Suffolk Pink, Cream, Sandstone, Portland Stone, Parchment, Buttermilk (BS10-C-31), Gardenia (BS10-B-15), Magnolia (BS08-B15).