Remove dirt, grease, oil, loose rust and all other surface contaminants by appropriate means.
Sand intact coatings to provide a proper key for adhesion.
The surface must be clean and dry during application.
For good results the relative humidity shall be below 85% and the temperature of the can and substrate above 0°C.
Remove cover cap. Shake vigorously for at least one minute after the rattle of mixing balls is heard. Shake frequently during use.
Hold can approx. 25 cm from surface. Use back and forth motion keeping can parallel with surface. Ensure that can is in motion when spray button is pressed to avoid runs and sags.
Apply several thin layers at a few minutes interval to achieve adequate coating thickness.
After use turn can upside down and press spray button for 2 - 3 seconds to clean valve.
Bright topcoats may need a light coloured primer/intermediate coat.